Top five TBC and thermoduric watch outs for June

Thermodurics are heat resistant bacteria; they can be found everywhere, but mainly in soil, dust (where they are air borne), in bedding and in faeces, and therefore they can get into and lodge in a poorly sanitised milking plant or processing plant.

June tends to be one of the warmer months, which means there is a greater opportunity for bacteria to build up under a biofilm in your plant or bulk tank. If a bulk tank isn’t kept clean, bacteria will get established and these can negatively affect product quality and reduce product shelf life.

Biofilms can quickly build up in a bulk tank that isn’t being washed correctly or where milk isn’t being stored correctly. A biofilm is where layers of bacteria develop a protective shell growing on the stainless-steel surfaces. This protective shell then protects them from detergents and cleaning agents. A biofilm will then trap other bacteria and can then shed large numbers of thermoduric bacteria into the incoming fresh milk.

This month’s top five tips are all about the Bulk tank as this is often where Thermoduric bacteria will build up. Ensure you are fully washing the bulk tank with hot water and the correct number of detergents after each collection. Drain the tank fully to ensure no residues of detergent build up. Ensure you tank is fully serviced and ready for the summer months.

Five areas to focus on for June

Temperature – ideally milk should be cooled as quickly as possible to 4C which minimises risk of bacterial growth. If your bulk tank isn’t capable of cooling milk this quickly, you will get bacteria building up, especially where milk stays over 6C for any extended time. Water supply can be an issue that can impact cooling capacity in warmer times when cows are consuming large amounts of water and this can affect supply to the dairy, the plate cooler and the bulk tank. If your bulk tank is still agitating and trying to cool milk hours after milking this not only sees bacteria grow but is very energy inefficient and will cause buttering in the milk. Ensure the coolant gas is kept topped up - if gas is low, cooling will not be quick or efficient.

Capacity – your bulk tank should be large enough to hold five milkings. A bulk tank that is too small will be under pressure, as there will always be fresh warm milk coming in with little or no cooled milk to aid cooling. The other aspect to remember is that milk cooling accounts for up to 40% of electricity usage so it is important to maximise your tanks energy efficiency by optimising its size. Precooling milk by using a plate cooler is more energy efficient and will reduce any opportunity for bacteria to build up. Remember to always use a filter to protect the plate cooler during the wash cycle.

Compressors – as ambient temperatures warm up, compressors will be under pressure. Ensure they are clean and dust free to keep them as efficient as possible.

Tank outlet – ensure you keep this clean. If this is neglected bacterial film will build up here, and as all the milk has to pass through when being pumped on to the milk truck, it will raise the bacterial count of the milk. Manually cleaning this after each collection is key.

Torch – use a torch to check the inside of your bulk tank after each collection. Look for a shiny clean surface, ensure the agitator blades are working and turning, make sure there is no ‘rainbow’ shine or layer of film building up. For advice on farm to deal with thermoduric or TBC issues contact your Milk Supply Manager.

Some helpful Videos on Milk Quality issues:

John Fitzpatrick and Fionnuala Malone: https://bit.ly/2XW6cAT

William O’Toole: Plant Maintenance https://youtu.be/Bm84NxuwC8g

Eamonn Comaskey: TBC issues https://youtu.be/CbLP52AzkUc

First Published 27 June 2022

Tagged with: Dairy

Processing