Thermodurics – Prevention is better than cure

Cluster-684.jpg

Thermodurics are heat resistant bacteria that can be found mainly in soil, in dust (where they are air borne) and in bedding and faeces, therefore, they can lodge in a poorly sanitised milking plant or processing plant where they have the capacity grow to large numbers.


Biofilm and what is it?  

Simply put, biofilms are layers of bacteria that grow on the organic deposits that are already attached to the internal surfaces of milk pipework. They develop a protective shell which protects them from detergents and cleaning agents. They are typically found in milk plants both on farm and in factory where there is a regular flow of milk. Milk is an ideal food for this bacteria as it is packed with nutrients.

As the milk flows through the pipeline system, organic material will settle and deposit on the surface of the pipe.  Bacteria that are flowing through the pipe are able to attach themselves to these organic deposits and some bacteria (given the right amount of time and temperatures) will multiply and form a protective layer called a Biofilm.

This biofilm will trap other bacteria and nutrients to support its growth, harbouring both harmless and harmful thermoduric bacteria and pathogens. Once established the biofilm will shed large numbers of thermoduric bacteria into the oncoming fresh milk during milking.

Biofilms are everywhere from plaque on your teeth, to the slime that is on rocks in a stream, to the surface of a kitchen sink.


To check for biofilm and Thermoduric build up

Mature biofilms can be visible when you swab the internal surface of pipes with cotton buds looking grey/brown in colour and feel rough and waxy matrix to touch. But not all are easy to find.


How to avoid

Prevention is the best cure.  Thermoduric Results of 150 cfu/ml or less is what will be achieved proper wash routines.

If milk samples contain > 150 this is an indication that the wash routine is incorrect. See below examples of improper wash cycles.

  1. Wash temperature too low, needs to be >70C.
  2. Detergent strength too low.
  3. Flow rate or volume of detergent wash too low – needs to be 15 litres per litre.
  4. Dirty vacuum line – needs to be kept clean at all times.
  5. Old & worn rubber ware.
  6. Irregular descale and caustic wash program.
  7. Clean dry teats for all milkings. Dry conditions, followed by rain often will see large numbers of bacteria on cows teats at milking – not always being washed off by pre milking preparation. Dusty teats are not clean teats.


Cleaning/Removal of biofilm

Once a biofilm is established, it can be difficult to remove under a normal washing routine; so it’s best to first complete a  hot descale wash, followed by an extra strong hot caustic wash >70C. Note Dump water temperature after 7 minutes should be > 55 degrees.

For further information please contact The Milk Quality Team.

Some helpful Videos on Milk Quality issues

William O’Toole: Plant Maintenance

Eamonn Comaskey: TBC issues

Tom Phelan: SOPs

Fionnuala Malone: Antibiotic Testing

 

First Published: 15 June 2021

Tagged with: Dairy

Processing