Keeping the focus on thermoduric bacteria

Udders_684x384.jpg

Thermoduric issues arise from heat resistant bacteria coming initially from cows’ teats and udders building up on equipment due to a poor wash routine. These bacteria then come through in the milk and into the factory.

Higher thermoduric levels can occur in milk due to the warmer weather which allows bacteria to get a better foothold in milking machines and tanks than in colder weather. High levels are an indicator that hygiene is not currently good.

The source of thermoduric and all other bacteria is from the outside of the teats -especially if teats are not being cleaned prior to milking. Dust (which is often unseen) and dirt on the outside of teats is the chief concern. By allowing this to stay on teats and then get into your milking machine and bulk tank, the milk can then become contaminated with high risk bacteria that can lead to food poisoning and spoilage.

Prepping cows before milking is better in the long run as it improves mastitis detection and avoids bacteria getting into your equipment, and thus eliminates problems. It also allows for better milk let down by the cows and milking cows will be faster, with better milk-out.

  • Check your hot water is hot enough and of sufficient volume to really clean your milking equipment
  • Increase descaling frequency to beat the warmer weather risk period
  • After you descale, rinse and then do a detergent wash immediately, to ensure no resettlement of bacterial build up
  • Check that vacuum lines are clean
  • Replace old or perished rubberware
  • Wash and dry cows teats to prevent thermoduric bacteria getting into the milking machine in the first place

Thermoduric levels for a clean machine and bulk tank should be less than 200 cfu/ml, if you have a Thermoduric issue – please contact you Milk Quality Manager for help solving this issue.

Further information is available on these videos :

Updated on 9 June 2020

Tagged with: Dairy

Processing