Feeding for breeding starts from calving
As weather conditions have recently improved, full-time grazing has become more regular on farm. However this transition period to full-time grazing must be managed carefully, always ensuring that the cow’s Dry Matter Intake (DMI) requirement & energy requirements are met.
Negative Energy Balance
It is the cow’s feed intake that ultimately drives performance in spring calving herds. A cow will reach her highest daily milk output 6-8 weeks post-calving but it is 4-6 weeks later before she reaches peak DMI. Therefore the cow is forced to use energy from her fat reserves, ‘milking off her back’, to make up the energy deficit for several weeks. Importantly, if the cow loses too much body condition in early lactation, it can reduce her chances of getting back in calf, or will affect when this happens. Milking cows need to receive adequate amounts of feed to ensure that they can meet the energy demands of maintenance and milk production while keeping body condition loss to less than 0.5 BCS between calving and breeding. As you can see from the graph below, the most critical time to ensure good cow nutrition is in the 60 days after calving, moreso than when the cows are actually being bred. For spring calving herds, the herd’s fertility will be decided by how well the cows are fed in February/March rather than April/May, meaning that how we manage the nutrition of the herd in the coming weeks is critical to a compact calving pattern in February 2020.

Dry Matter Intakes at grass
Dry Matter Intake will increase by 0.75 – 1.0 Kg per week post calving, until peak intake capacity of 17-20 kg DM is achieved.
The moisture content of grass can vary significantly in spring, and this can have a major impact on dry matter intakes (analysed ranges for week ending 22/02: 15.6 – 20.1 % DM). It is important not to overestimate the DMI a cow can get from grazing, or performance and fertility may be compromised. For example, a cow estimated to consume 12 kg of grass dry matter at 15% DM will require an intake of 80 kg fresh grass, which is a significant volume for the cow to consume easily. Buffer feeding should be strategically implemented during periods of wet weather, when required grass DMI cannot be maintained due to low dry matter of the grass. Alternatively, extra concentrate feed can be given during these periods of wet weather when DMI will otherwise be reduced.
Meeting Energy Requirements of the cow
Cow type is a major decision driver on farm in regards to energy requirements, with milk fat % also driving UFL requirements/litre produced in the freshly calved cow.
When calculating energy requirements the following table can be used as a general guide:
|
Assume |
650 kg cow Producing 27 litres/day |
|
UFL Requirement |
6.4 UFL Maintenance requirement 0.45 UFL/litre of milk produced |
|
Total UFL requirement |
18.28 UFL |
|
Grass Supply |
14 kg DM @ 0.95 UFL = 13.3 UFL |
|
UFL Deficit Required |
Requirement – grass offered = 5.0 UFL Deficit |
|
Supplementary concentrates required @ 0.95 UFL |
5.26 kg conc / day |
If you require any further information on feeding your herd this spring, do not hesitate to contact your local Glanbia representative.
First Published 26 February 2019
Tagged with: Agribusiness Co-op Dairy